3 in 1 busbar machine operating steps

The 3-in-1 busbar processing machine is a CNC equipment. Its working principle is to control the operation of the machine through a computer program to realize shearing, punching and bending of busbars.

Specifically, the workflow of the three-in-one busbar processing machine is as follows:

First, the busbar is placed on the workbench of the machine, and the computer program controls the machine’s shearing tool for shearing. After shearing is completed, the machine sends the busbar to the punching area, and the computer program controls the machine’s punching tool to punch. Finally, The busbar is sent to the bending area, and the bending tool of the machine is controlled by the computer program for bending. The entire work process is controlled by a computer program, realizing automated production.

busbar Cutting unit operation method

1. Remove the auxiliary presser foot of the cutting support table and unscrew the screws fixing the lower mold.

2. Press the down switch and move downward until the upper and lower molds stop at the matching position, then turn off the power.

3. Unscrew the screws fixing the lower mold and confirm the gap. The gap should be just enough to place a piece of folded white paper between the upper and lower molds so that the screws that secure the lower mold can be tightened.

4. Turn on the power. Move the upper mold up and then slowly lower it to confirm.

After adjusting the gap between the upper and lower molds, assemble the auxiliary presser foot and start the operation.

busbar bending unit operation method

1. Select the upper and lower bending molds according to the material, thickness, width and angle to be processed.

2. Depending on the type of processing, the upper bending mold (3-10 t: 6R; 10-15 t: 10 R) is rotated 180 degrees before using the lower bending mold (3-10 t: 45mm; 3-10 t: 68mm) Use the handle to remove and replace.

3. When performing operations above 90 degrees, the limit adjustment lever can be used to adjust the angle.

busbar punching unit operation method

1. You should first clean up the foreign objects in the appliance, then unscrew the two screws on the lower mold support table, and take out the support table and the lower mold.

2. After unscrewing the screws fixing the mold, adjust the screws in the unscrewing direction and take out the upper mold from the bottom.

3. When assembling, proceed in reverse order of disassembly. Check whether the upper and lower molds match. Confirm slowly with the down button switch.